SAFETY
MONITORING RELAY. 2NC OUTPUTS.
IDEM’s
SCR-2 is an all purpose safety monitoring relay that ensures the quick and safe
deactivation of the moving parts of a machine in case of danger.
Applications
include single and dual channel emergency stop circuits or dual channel safety
guard monitoring using Tongue Switches or Non Contact Switches.
The
internal logic system closes the relay safety outputs when the start button is
pressed.
If the
control lines are opened by operation of a safety switch or E-stop button then
the safety output contacts are opened and safely switch off the supply to the
machine. It is ensured that a single fault does not lead to the loss of the
safety function and that cyclic monitoring means that any fault is detected no
later than the next start up.
Featuring:
Two Force
Guided Safety Output Contacts.
Standards:
EN60204-1, EN954-1, ISO13849-1, EN62061.
Stop
Category 0.
Up to
Category 4 to EN954-1.
Up to PLe
to ISO13849-1.
SILCL3
EN62061.
Single or
Dual Channel input with LED indication of input status.
Redundancy
and cycle monitoring.
Feedback
loop for monitoring contacts or expansion modules.
Short
circuit and earth fault monitoring.
22mm Din
Rail Mounting.
sc2:安全監控繼電器
安全監測繼電器。
2數控輸出。
IDEM的scl -2是一種萬能安全監控繼電器，確保在危險情況下快速和安全地關閉機器的移動部件。
應用包括使用舌形開關或非接觸開關的單通道和雙通道緊急停止電路或雙通道安全保護監控。
當啟動按鈕被按下時，內部邏輯系統關閉繼電器安全輸出。
如果控制線路通過安全開關或E-stop按鈕操作斷開，則安全輸出觸點斷開，安全切斷給機器的電源。
確保單個故障不會導致安全功能的丟失，循環監控是指在下次啟動之前檢測到任何故障。
特色:
兩個力引導安全輸出觸點。
標準:EN60204-1、EN954-1、ISO13849-1、EN62061。
停止類別0。
4級至EN954-1。
可達PLe至ISO13849-1。
SILCL3
EN62061。
單路或雙路輸入，LED顯示輸入狀態。
冗余和循環監控。
反饋回路監測接觸或擴展模塊。
短路和接地故障監測。
22mm
Din Rail安裝。
聯系人：侯經理 聯系人：13661967205
